Cisco Multi-Stream CableCARD Module Guía De Instalación
![Cisco](https://files.manualsbrain.com/attachments/7380d0050044647c30f5c24bbbf5d0c0b6d9bb84/common/fit/150/50/faa183d287233c52228cfea3dbc2a127fe780f60564fcb0955d9c3d1cd23/brand_logo.png)
78-4017672-01 Rev E
95
E
Appx auto letter
Appendix E
Manually Configure the PCG
Introduction
Systems that do not allow BOOTP/TFTP between the DNCS/ISDS
and PCG must manually configure the PCG so that it does not issue
BOOTP/TFTP requests.
and PCG must manually configure the PCG so that it does not issue
BOOTP/TFTP requests.
Note: If your system does not allow BOOTP/TFTP between the
DNCS/ISDS and PCG, perform these steps immediately after
installing the PCG software.
DNCS/ISDS and PCG, perform these steps immediately after
installing the PCG software.
Important: Perform the procedures in this section only after you have
completed a software installation or upgrade.
completed a software installation or upgrade.
In This Appendix
What's Next? ........................................................................................ 102