Cisco PowerKEY CableCARD Module 800 Guía De Instalación

78-4017672-01 Rev E

Appx auto letter

Appendix E

Manually Configure the PCG

Introduction

Systems that do not allow BOOTP/TFTP between the DNCS/ISDS
and PCG must manually configure the PCG so that it does not issue
BOOTP/TFTP requests.

Note: If your system does not allow BOOTP/TFTP between the
DNCS/ISDS and PCG, perform these steps immediately after
installing the PCG software.

Important: Perform the procedures in this section only after you have
completed a software installation or upgrade.

In This Appendix



