Cisco PowerKEY CableCARD Module 800 Guía De Instalación
Configure the Network Interface
78-4017672-01 Rev E
35
Configure the Network Interface
Complete the following steps to configure the PCG network interface to support
secure application downloads between the PCG servers and the DNCS/ISDS.
1 Open an xterm window on the DNCS/ISDS.
2 Type ping -a dncsatm and press Enter.
secure application downloads between the PCG servers and the DNCS/ISDS.
1 Open an xterm window on the DNCS/ISDS.
2 Type ping -a dncsatm and press Enter.
Example output:
dncsatm (10.250.0.1) is alive.
Note: The IP address in your output is the value of the DNCSATM for the
remainder of this section.
remainder of this section.
3 Connect a monitor and keyboard to the PCG device. Once these are connected,
the pcg login: prompt should appear.
4 At the pcg login: prompt, enter the root user name and press Enter.
5 At the Password: prompt, enter the root password and press Enter.
5 At the Password: prompt, enter the root password and press Enter.
Note: The password is not included in this document. If you require assistance,
contact Cisco Services.
contact Cisco Services.
6 Open the /etc/sysconfig/network file with a text editor.
7 Change the HOSTNAME parameter to the hostname of the PCG.
7 Change the HOSTNAME parameter to the hostname of the PCG.
Example:
HOSTNAME=PCG001-V001
8 Save and close the network file.
9 Execute the following command to change the active hostname on the PCG:
9 Execute the following command to change the active hostname on the PCG:
hostname <hostname>
Note: Replace <hostname> with the desired hostname of the PCG.
Note: Replace <hostname> with the desired hostname of the PCG.
10 From the PCG, open the file /etc/sysconfig/network-scripts/ifcfg-eth0.
11 Perform the following changes:
11 Perform the following changes:
a Change the value of the directive BOOTPROTO to static.
b Change the value of the directive IPADDR to the value of [PCG IP Address].
b Change the value of the directive IPADDR to the value of [PCG IP Address].
You previously entered this value in the GUI.
Example: If the value of PCG IP Address is 172.18.0.1, the parameter must
appear as follows:
appear as follows:
IPADDR=172.18.0.1
c Change the value of the directive NETMASK to the value of [PCG IP Subnet
Mask]. You previously entered this value in the GUI.