Cisco Multi-Stream CableCARD Module Guía De Instalación
Chapter 4 PKES Software Installation and Configuration
32
4034718 Rev B
Editing the trapDestinationTable File
Complete these instructions to edit the trapDestinationTable file.
1 At the PKES, type cd <PKES pkg>/config and then press Enter. The <PKES
1 At the PKES, type cd <PKES pkg>/config and then press Enter. The <PKES
pkg>/config directory becomes the working directory.
Note: Substitute the directory in which the PKES package is located for <PKES
pkg>.
Note: Substitute the directory in which the PKES package is located for <PKES
pkg>.
2 Type vi trapDestinationTable and then press Enter. The trapDestinationTable
file opens for editing in the vi text editor.
3 Edit the trapDestinationTable file so that the hostname and IP address of each
NMS are included in the file, each on a separate line.
Example:
Example:
#
# SNMP Trap Destination Table
# This table defines the set of destinations for each trap created by
PKES.
PKES.
# The entries in the table consist of:
#
# NMS Hostname (string)
# NMS IP address (string)
#
Nms1, 10.90.176.60
Nms2, 10.90.176.61
Nms3, 10.90.176.62
4 Save the file and close the vi text editor.
Set the SNMP Version for PKES Traps
The default SNMP version for PKES SNMP traps is 3. Complete these instructions if
a version of SNMP other than SNMPv3 is desired for the SNMP traps.
1 Type the following command and press Enter to open the snmp.conf file with a
a version of SNMP other than SNMPv3 is desired for the SNMP traps.
1 Type the following command and press Enter to open the snmp.conf file with a
text editor:
vi /usr/share/snmp/snmp.conf
vi /usr/share/snmp/snmp.conf
2 Change the defversion value to the desired SNMP version for PKES traps.
Example:
defversion 2c
3 Save and close the snmp.conf file.