Cisco PowerKEY CableCARD Module 805 Guía De Instalación
The PKES Hardware
4034718 Rev B
3
The PKES Hardware
We occasionally update the PKES hardware to take advantage of newer technologies
as they become available. This guide presents examples based on a typical server
configuration.
as they become available. This guide presents examples based on a typical server
configuration.
Refer to the hardware install guide provided with your PKES server for specifics on
how to physically install the server and for safety recommendations regarding
server placement and cooling requirements.
how to physically install the server and for safety recommendations regarding
server placement and cooling requirements.
Before beginning your installation, read the Safety Precautions (on page vi) at the
beginning of this document. Pay particular attention to the Placement topic in the
Safety Precautions section.
beginning of this document. Pay particular attention to the Placement topic in the
Safety Precautions section.
Site Requirements
Your site must meet the following requirements before you proceed with the
installation:
installation:
The hardware must be installed in a standard four-post rack. See Rack
Mounting (on page 4) in the next section for the rack requirements.
Mounting (on page 4) in the next section for the rack requirements.
Approved power sources: 90 to 120 V AC (continuous)
Racking and environment temperature: Inside rack temperature must be
maintained at between 0
maintained at between 0
and +50
C (32
and 122
F)
Note: A monitor and keyboard or a PC connected via the serial interface will be
needed for initial setup of the PKES. These peripherals are not needed for normal
operation or day to day troubleshooting.
needed for initial setup of the PKES. These peripherals are not needed for normal
operation or day to day troubleshooting.