Cisco Cisco D9824 Advanced Multi Decryption Receiver Guía De Instalación
Chapter 5 Web GUI Setup and Monitoring
206
OL-29015-01
FEC Scheme
Description
Non-Block Aligned Each FEC packet receives L packets after the last related data
packet.
11 Click Apply.
Setting Up the MPEG over IP Auto Synchronization Options
The MoIP Auto Sync section allows you to configure the DPM without editing each
output channel and PID separately.
1 In the MPEG over IP Output page (Transport Stream > MPEG over IP Output),
output channel and PID separately.
1 In the MPEG over IP Output page (Transport Stream > MPEG over IP Output),
refer to the MoIP Auto Sync section.
2 From the Enable Auto Fix for Collision drop-down list, choose Yes for the DPM
to resolve channel and PID collisions automatically on the transport outputs.
New values are assigned to the parameters that caused the conflict. The new
assigned values are not used by any incoming transport or other PE outputs. If a
collision is detected, you can review the new changes and click Apply to accept
the new changes.
Choose No and a detailed list of all the conflicts is displayed in the Output
Channel and PID Conflicts table (click View Conflicts) when a conflict occurs.
You can then resolve the conflicts manually.
New values are assigned to the parameters that caused the conflict. The new
assigned values are not used by any incoming transport or other PE outputs. If a
collision is detected, you can review the new changes and click Apply to accept
the new changes.
Choose No and a detailed list of all the conflicts is displayed in the Output
Channel and PID Conflicts table (click View Conflicts) when a conflict occurs.
You can then resolve the conflicts manually.
3 From the Enable Fixed Output drop-down list, choose Yes for the DPM to assign
new values for all the output channels and PIDs according to the Fixed Output
Options table when you Resynchronize All. Click Fixed Output Options to
configure the MoIP Fixed Output Options:
Options table when you Resynchronize All. Click Fixed Output Options to
configure the MoIP Fixed Output Options:
a From the Use Input Channel Numbers drop-down list, choose Yes to use the
input channel numbers. Otherwise, choose No (default) to use the first
channel and channel offset assigned below.
channel and channel offset assigned below.