Cisco Cisco D9858 Advanced Receiver Transcoder Guía De Instalación

 

168 

OL-29012-01 

1  From the user interface of the D9858, choose Audio & Video > Cueing > Cue 

Tone. The Cue Tone page is displayed. 

2  The Sequence Number lists the tone sequences. The receiver supports up to 16 

tone sequences. You can configure the state, tones, mode, and delay for each tone 
sequence. 

3  From the Sequence State drop-down list, choose to enable or disable the current 

tone sequence. When disabled, no cue tone is output. 

4  In the Sequence Tones field, set the three digit tone sequence (1 to 999). 
5  Choose the tone sequence mode from the Sequence Mode drop-down list. 

Choose * for start tone, # for the end tone, and */# for the start and end tones. 
The end tone is signaled after waiting the time specified in Sequence Delay. 

6  If the Sequence Mode was set to */# (Start/Stop), set the Sequence Delay, in 

seconds, between the start and stop sequences. You can enter a value in the 
range from 1 to 255. The default is 30. 

7  Click Apply.