Cisco Cisco D9804 Multiple Transport Receiver Guía De Instalación
Setup Menu
78-4042990-01 Rev B
63
Menu Item
Description
Parameters
Reg ID
Sets the transport ID for the regional
stream.
stream.
1 to 65535
Regional Stream
Name
Name
Displays the name of the selected
regional stream, provided by the
uplink.
regional stream, provided by the
uplink.
Up to 31 alphanumeric characters
Out Params: Apply
Local
Local
Sets the output routing mode. Applies
the local routing settings/parameters.
the local routing settings/parameters.
When Inband Data is set to Ignore,
Apply Local will cause the current
configuration settings to be saved, then
applied as described in the table
above. Note that the configuration
must be valid for it to be saved.
Apply Local will cause the current
configuration settings to be saved, then
applied as described in the table
above. Note that the configuration
must be valid for it to be saved.
If the operator is currently editing the
ASI port configuration, the unsaved
changes must be saved first. If the
unsaved changes are not valid, the
operator will be prompted to continue
editing or to abandon the changes
before Apply Local can be used to
update the routing configuration.
ASI port configuration, the unsaved
changes must be saved first. If the
unsaved changes are not valid, the
operator will be prompted to continue
editing or to abandon the changes
before Apply Local can be used to
update the routing configuration.
The following shows the
differences in how the Apply Local
function applies settings for the
different Inband Data settings:
differences in how the Apply Local
function applies settings for the
different Inband Data settings:
Ignore - All local settings are
applied.
applied.
Apply - Applies (ASI port)
Enabled state, Inband Data mode,
Format, PCR Correction, Bit Rate,
Burst Mode, CT ID, CT Name, and
Packet Loss Adjustment. All other
settings are obtained from
information transmitted by the
uplink for the Combined
Transport ID (CT ID) specified for
the local settings.
Enabled state, Inband Data mode,
Format, PCR Correction, Bit Rate,
Burst Mode, CT ID, CT Name, and
Packet Loss Adjustment. All other
settings are obtained from
information transmitted by the
uplink for the Combined
Transport ID (CT ID) specified for
the local settings.
Uplink - Applies Rate, Rate Type,
PCR Correction, Error Correction,
and Burst Mode. No other local
settings are applied.
PCR Correction, Error Correction,
and Burst Mode. No other local
settings are applied.
Note: The ASI output port is
forced to enabled when Uplink
mode is active. The port remains
enabled until Apply Local is
initiated to restore the local
settings (provided Uplink control
is no longer active).
forced to enabled when Uplink
mode is active. The port remains
enabled until Apply Local is
initiated to restore the local
settings (provided Uplink control
is no longer active).
Out Params: Get
Current
Current
Sets the output routing mode. Reads
the implemented routing configuration
for the selected output port and
updates the output configuration
according to the current settings.
the implemented routing configuration
for the selected output port and
updates the output configuration
according to the current settings.
Filter
Sets the PID for Drop and Pass for each
output.
output.
The Filter Info is only applicable to
Drop and Pass output streams.
Drop and Pass output streams.
1 to 8