Cisco Cisco D9804 Multiple Transport Receiver Referencia técnica
Connecting the Unit
4043035 Rev A
7
FPGA Version
Description
2.00
DM mode functions:
Up to four independent decombine, raw, pass, drop output
formats that can be routed to the ASI output ports, and one
independent Deterministic Remultiplex function (remux) that can
be routed to the ASI output ports.
formats that can be routed to the ASI output ports, and one
independent Deterministic Remultiplex function (remux) that can
be routed to the ASI output ports.
Proceed as follows to select the FPGA version:
1 Move to the Versions menu and use the up and down arrow keys to navigate to
the FPGA Version entry.
2 Press SELECT and use the up and down arrow keys to scroll the list of available
FPGA versions.
3 Press SELECT to select the displayed FPGA version.
4 Press the right arrow key to navigate to the Select menu Alipress SELECT. You
4 Press the right arrow key to navigate to the Select menu Alipress SELECT. You
will be prompted to Abort or Continue. The FPGA version is loaded the next
time the D9804 MTR is rebooted.
time the D9804 MTR is rebooted.
Setting up RF Tuning Parameters
1 Move to the Tuning menu and use the up and down arrow keys to navigate to
and set the following parameters.
Entry/Selection
Options
Enabled
Set to Yes to enable the input.
Inband Data
Set to Ignore to use local data.
Input
4 RF ports to select.
Modulation
DVB-S or DVB-S2. If set to DVB-S2, set FEC to Auto.
Downlink Frequency Type in frequency (GHz).
Set FEC
If the FEC is unknown, leave it at "auto". It must be set to Auto if
DVB-S2 modulation is used.
DVB-S2 modulation is used.
Set LNB Voltage
RF1, RF2, and RF3
Note: Only RF1 to R3 have DC power.
LNB Voltage options - 13, 18, and OFF.
Set LO frequency
LO (Local Oscillator) frequency in GHz.
Rolloff
Only required for DVB-S2.
IQ
Normal, Inverted, or Auto.
2 Press MENU to exit and save the changes.