Cisco Model GS7000 4-Port Node 1 GHz with 42 54 Split Guía De Instalación
Local Control Module
Configuration Procedure
4024769 Rev A
25
Forward Seg: 3xRx1,2,4FS
The default settings for 3xRx1,3,4FS are as follows:
Reverse Port 1, 2, 4, and 5: On, 0 dB
Forward Seg: 3xRx1,3,4FS
Note: See LCM Configuration Parameters (on page 18) for other setting
options.
The default settings for 3xRx1,3,4FS are as follows:
Reverse Port 1, 2, 4, and 5: On, 0 dB
Forward Seg: 3xRx1,3,4FS
Note: See LCM Configuration Parameters (on page 18) for other setting
options.
WARNING:
The Model GS7000 Node's forward segmentation is set at the factory to match
the installed Forward Configuration Module (FCM). A mismatch between the
forward segmentation and the FCM may cause isolation or loss of service.
WARNING:
If RX1 fails when the node's forward segmentation mode is set to 3xRx1,3,4FS
the headend will lose communication with the node.
Note: Other LCM menu items are not directly related to configuration of the node,
but are primarily read-only status indications. Other menu items of interest are:
but are primarily read-only status indications. Other menu items of interest are:
Menu item 9 - Restore Defaults, that allows the restoration of the default settings
which is for a fully populated node with two AC lines, two power supplies, four
receivers, and four transmitters installed.
which is for a fully populated node with two AC lines, two power supplies, four
receivers, and four transmitters installed.
Menu item 9 - Copy Parameters, that allows you to store up to nine node
configuration parameter settings and copy (restore) them to another LCM
located in different node.
configuration parameter settings and copy (restore) them to another LCM
located in different node.