Cisco Headend Digital Broadband Delivery System Guía De Instalación
Appendix B
Upgrade the xOD Client Software
138
78-4004034-01 Rev C
Upgrade the xOD Client
Introduction
This section describes how to upgrade the xOD client software on the ASI server.
Before You Begin
Before you begin to upgrade the xOD client software, you must upgrade the ASI
Server software to 1.6.0. You also need the following items to upgrade the xOD
client:
ASI server asset user privileges and password (from your system administrator)
ASI server root user privileges and password (from your system administrator)
xOD Client 1.6.0 CD
IP address or host name (usually asi) for the ASI server
IP address or host name (usually dncs) for the DNCS
A test DHCT and television
Time to Complete
Upgrading the xOD client takes approximately 40 minutes to complete.
Performance Impact
When you finish upgrading the xOD client, the next time an authorized DHCT tunes
to an xOD channel, it will update its xOD client software. Therefore, the next time
subscribers try to tune to an xOD channel, the DHCT will take a few seconds longer
than usual to load the channel.
Creating an Out-of-Band BFS Source
Complete these steps to create an out-of-band BFS source.
Important: Skip this procedure if the out-of-band source is already configured.
1 With the Sources tab in the forefront of the BFS Administration window, click
Important: Skip this procedure if the out-of-band source is already configured.
1 With the Sources tab in the forefront of the BFS Administration window, click
File and select New. The Set Up BFS Source window opens.
2 Click in the Source Name field and type SAIXOD_OOB. This should be the
same name that you entered when you added the DNCS source.