Cisco Prisma II bdr Dig Rev 2 1 Dual Mux Sys for High Density Installations Guía De Instalación
Reverse Balancing the Node with the Enhanced Digital Reverse Modules 78-741939-01 Rev C
3-6
Port Combination Options,
Continued
Factory Default Port Combination in the Model 6944 Optical Node
This table gives the factory default cable color coding scheme used to differentiate
the cables for the four RF connectors in the Model 6944 Optical Node.
Port Identifier on
the Node
Cable Color Code
Connection on the 2:1 Enhanced
Multiplexing Digital Module
Port 1
Blue
Top
Port 3
White
Second to top
Port 4
Black
Second to bottom
Port 6
Green
Bottom
Notes:
•
If the above color code recommendation is followed, then the black and green
cables connect to ports 4 and 6 whose reverse paths are combined. The blue and
white cables connect to ports 1 and 3 whose reverse paths are combined.
•
The opposite end of the colored coax cables should be connected to the node
ports whose reverse paths are to be combined.
•
Internally, the signals of the two lower RF input connections are combined to
provide a single RF signal. Similarly, the signals of the two top RF input
connections of the 2:1 enhanced multiplexing digital module are combined and
further coupled with the Status Monitoring Input signal to provide a second RF
signal. Refer to the Block Diagram of the 2:1 Enhanced Multiplexing Digital
Module in Chapter 1.
Port Combination Option in the Model 6944 Optical Node
In order to better balance the reverse path signals, the ports can be connected
differently than shown in the table above. The following table gives an example of
connecting the ports differently.
Port Identifier on
the Node
Cable Color Code
Connection on 2:1 Enhanced
Multiplexing Digital Module
Port 1
Blue
Top
Port 4
Black
Second to top
Port 3
White
Second to bottom
Port 6
Green
Bottom