Cisco Headend System Release 2.5 Guía De Instalación
Place Disaster Recovery Jobs on Hold
4042389 Rev A
99
Place Disaster Recovery Jobs on Hold
Complete the following steps to place Disaster Recovery jobs on hold.
1 Log in to the Active MC's Disaster Recovery GUI with the following credentials
1 Log in to the Active MC's Disaster Recovery GUI with the following credentials
Username = dradmin
Password = dradmin
2 In the Synchronization Status block, select Near Real-Time Sync.
3 Under the Action column on the extreme right side of the GUI, select Hold.
4 On the left navigation panel, select DBDS Status.
5 In the Synchronization Status block, select Periodic Sync.
6 Under the Action column on the extreme right side of the GUI, select Hold.
7 On the left navigation panel, select DBDS Status.
8 In the Maintenance Status block, select Audit.
9 Under the Action column on the extreme right side of the GUI, select Hold.
10 On the left navigation panel, select DBDS Status.
11 In the Maintenance Status block, select Backup Primary DNCS.
12 Under the Action column on the extreme right side of the GUI, select Hold.
13 On the left navigation panel, select DBDS Status.
14 In the Maintenance Status block, select Backup Standby DNCS.
15 Under the Action column on the extreme right side of the GUI, select Hold.
3 Under the Action column on the extreme right side of the GUI, select Hold.
4 On the left navigation panel, select DBDS Status.
5 In the Synchronization Status block, select Periodic Sync.
6 Under the Action column on the extreme right side of the GUI, select Hold.
7 On the left navigation panel, select DBDS Status.
8 In the Maintenance Status block, select Audit.
9 Under the Action column on the extreme right side of the GUI, select Hold.
10 On the left navigation panel, select DBDS Status.
11 In the Maintenance Status block, select Backup Primary DNCS.
12 Under the Action column on the extreme right side of the GUI, select Hold.
13 On the left navigation panel, select DBDS Status.
14 In the Maintenance Status block, select Backup Standby DNCS.
15 Under the Action column on the extreme right side of the GUI, select Hold.