Cisco Headend Digital Broadband Delivery System Guía Del Usuario
Chapter 2 Staging the Tuning Adapter
14
4025012 Rev B
Overview
This section contains procedures for staging area personnel to stage Tuning
Adapters.
Important: Some billing systems automatically send EMMs to devices when you
Important: Some billing systems automatically send EMMs to devices when you
scan the bar code and/or when you move the device from inventory to a technician's
account in the billing system. If your billing system sends EMMs to devices when
you scan the bar code, make sure that the Tuning Adapters are connected to an RF
signal, have already downloaded software, and currently display either the service
disconnect (Brick mode indicator – LED blinks 8 times, pauses, then repeats) or the
ready state (steady-on LED) before you scan the device into the billing system.
Note: If the Tuning Adapter LED remains off and does not indicate either brick
Note: If the Tuning Adapter LED remains off and does not indicate either brick
mode or the ready state, the Tuning Adapter is probably in standby mode. To take
the Tuning Adapter out of standby mode, press the POWER button on the front
panel.