Cisco Headend System Release 2.7 Guía Para Resolver Problemas
Configure Weekly Tests
4024428 Rev B
47
Configuring Weekly Tests
After you set up the RWT, you need to set up the MMM Server. The ISDS uses the
MMM Server to conduct tests of the EAS. Follow these instructions to configure the
MMM Server on the ISDS for the RWT of the EAS.
1 On the ISDS Administrative Console, click the ISDS tab.
2 Click the System Provisioning tab.
3 Click MMM Config. The MMM Configuration List window opens.
4 Double-click configuration Cfg00 to use for the RWT. The Set Up MMM
1 On the ISDS Administrative Console, click the ISDS tab.
2 Click the System Provisioning tab.
3 Click MMM Config. The MMM Configuration List window opens.
4 Double-click configuration Cfg00 to use for the RWT. The Set Up MMM
Configuration window opens with the Force Tune Type tab in the forefront.
5 Click the Message Time tab.
6 In the Description field, type RWT configuration.
7 At your EAS encoder/decoder, locate the Default Duration value.
7 At your EAS encoder/decoder, locate the Default Duration value.
Note: If necessary, refer to the user guide that accompanied your EAS
encoder/decoder.
8 In the Delay Between Repeats field, type a value (in seconds) that equals
[(Default Duration/2) + 1 minute x 60]. Use whole integer division only (drop
the decimal point before adding the +1 minute).
Important: We recommend setting the Delay Between Repeats field to 480
Important: We recommend setting the Delay Between Repeats field to 480
seconds for the RWT if the default duration for the RWT is 15 minutes.