Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guía De Instalación
Chapter 4 Operation
310
78-4021139-01 Rev D
Type a name for your SNMP Provisioner. Use only valid characters A-Z, a-z,
and 0-9. To use the default name (dncsatm), just press Enter. The system
displays a message similar to the following:
host=dncsatm
Writing DNCS config file... Done.
Adding dncsatm entry to the /etc/hosts file... Done.
Note: In the example above, "dncsatm" is replaced by your specific host name
if you chose one.
p
Do you want to setup interfaces on the USRM server?
(yes/no)
(yes/no)
Answer "yes" if you want to set which protocols go with which ports. If you
answer “yes”, you will be prompted with question "p". Select which option, 1
- 3, that best matches your setup, or enter “4” to use the USRM default
settings.
q
Select a custom configuration:
(1) All USRM interfaces on one physical interface (eth0)
(2) Management on separate interface. (http on eth1, all
others on eth0)
others on eth0)
(3) MiniCarousel on separate interface. (MCP on eth1, all
others on eth0)
others on eth0)
(4) Defaults. Do not write a custom config.
Result: The system writes the USRM interfaces config file and then prompts
you with the following choices.
Setup Complete. Would you like to:
(1) Exit
(2) Restart Networking
(3) Reboot
Make a selection:
Note:
Entering "1" exits and saves your settings but does not put them into effect
until the next reboot.
Entering "2" saves the new settings and restarts the USRM to put them into
effect.
Entering "3" saves the new settings and clean reboots the USRM to put them
into effect.
Result: Server initial setup is complete.
Setting Static Routes
If your network setup requires the use of static routes, you can set those up using the
standard scripts available in RedHat Linux Enterprise 5. Follow these steps to setup
static routes:
1 Create a file /etc/sysconfig/network-scripts/route-ethX where X corresponds to the
1 Create a file /etc/sysconfig/network-scripts/route-ethX where X corresponds to the
network interface on which you want to set the additional route(s).