Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guía De Instalación
Initialize the Primary USRM Server
78-4021139-01 Rev D
451
Initialize the Primary USRM Server
Complete the following steps to initialize a primary USRM server.
Note: Only perform the following procedure when initializing a primary USRM
Note: Only perform the following procedure when initializing a primary USRM
server.
1 Start the USRM software as follows to set the operational role of the USRM to
1 Start the USRM software as follows to set the operational role of the USRM to
that of a primary server.
a Type the following command at the system prompt, and then press Enter:
a Type the following command at the system prompt, and then press Enter:
cd /opt/usrm
b Type the following command at the system prompt, and then press Enter:
./usrm
Allow the software to completely start. The following prompt appears:
Enter User ID: <enter>
2 After the software stops loading, terminate the USRM software by typing the
following command at the USRM/Pri: prompt, and then pressing Enter:
USRM/Pri: quit
3 Establish network connectivity to the USRM server by connecting each network
Ethernet cable into an Ethernet port on the rear panel.
4 Verify server network settings by typing the following command at the system
prompt, and then pressing Enter:
1) ifconfig -a (This will display the current networking settings. If
network settings are not correct, please execute the setupusrm.sh script
again.)
network settings are not correct, please execute the setupusrm.sh script
again.)
2) netstat -rn (This will display the network route settings and default
gateway in the Routing Table)
gateway in the Routing Table)
5 If static routes were defined on the failed primary server, use the commands
below to restore them. If not, skip to the next section, Start the Server in
Supervised Mode (on page 452).
6 Type the following command at the system prompt, and then press Enter:
3) cd /etc/sysconfig/network-scripts
4) Is -1 route-eth*
a) route-eth0
b) route-eth1
Note: If route files are not located in directory, copy files from standby server
into the directory.