Cisco Cisco StadiumVision Mobile Reporter Guía De Instalación
© 2011 Cisco Systems, Inc. All rights reserved
Page 19 of 71
3. At the front of the cover, you should see a small gap (approximately 1/8-inch
[3-mm]) between the chassis cover and the front of the appliance.
Figure 16. Installing the Cisco ADE 2140 Series Appliance Cover
4. Press down slightly on the cover behind the edge and slide the cover forward
until it click into place.
5. Reconnect all external cables and the AC power cord.
Removing the Front Bezel
Note: The following procedures assume your Cisco ADE 2140 Series appliance
came shipped with the front bezel installed.
came shipped with the front bezel installed.
Remove the front bezel to:
Install or remove hard drives or the optional DVD-ROM drive
Access the front-panel serial (console) port and USB ports
Observe the individual hard disk drive (HDD) activity and fault LEDs
Note: The appliance does not need to be powered down to remove the front
bezel.
bezel.
To remove the front bezel:
1. Unfasten the bezel retention screw on the right side of the chassis with a Number 2 Phillips
screwdriver.
2. Rotate the bezel outward and detach.
To install the front bezel:
1. Align the four tabs on the left of the bezel with the slots in the front panel and
then rotate the free end of the bezel to the closed position.
2. Snap the front bezel into place and tighten the screw at the right side of the
bezel.