Cisco Cisco StadiumVision Mobile Manual De Mantenimiento

Do one of the following:

Required for Initial Setup of the SV-4K for Operation in Cisco Vision Dynamic Signage Director Release
5.0

—

Provision the SV-4K according to the normal auto-registration process to download the required firmware
and WiFi credentials.

Note:

These steps do not detail firmware configuration. Be sure that you have already specified the required

firmware auto-registration settings for Cisco Vision Dynamic Signage Director Release 5.0.

See

and

If you have already provisioned the SV-4K for Cisco Vision Dynamic Signage Director Release 5.0:

—

Reboot the SV-4K from the Management Dashboard.

Enable wireless connectivity on a per-DMP basis. Go to:

Control Panel > Setup > Devices > DMP+Location

Select the SV-4K device(s) that you want to configure.

Beside the “Wifi Enabled” option, click Yes. Then, click Save.

Figure 2 WiFi Enabled Option Under SV-4K Device Settings

Note:

You can also use the BAT tool to set the Wifi Enabled property for SV-4K devices.

10.

Reboot the SV-4K.

11.

Verify WiFi connectivity is successful when the WiFi LED stays lit.

How to Deploy WiFi Network Connectivity on the SV-4K

Required Configuration