Cisco Cisco StadiumVision Director Manual De Mantenimiento
© 2012 Cisco Systems, Inc. All rights reserved.
Page 66 of 103
To define the relative volume steps:
1. On the Serial Commands tab for the desired TV type, click the + at the upper
right of the Available Serial Commands list box.
2. Click + at the upper right of the Available Serial Commands box and add a
corresponding command called dmp.RelativeVolumeSteps.
3. Press Enter.
4. The dmp.RelativeVolumeSteps will automatically be selected in the available list
Click << to add it to the configured list.
5. Select the dmp.RelativeVolumeSteps command in the configured list and click +
at the upper right of the Serial Strings of Selected Commands. Enter the
appropriate value for the steps (as described above).
appropriate value for the steps (as described above).
6. Press Enter.
7. Click Save.
Setting a Delay Between Repeated Serial Commands
Some models of TVs discard repeated serial commands that are sent too close
together. For those TVs, you can add and define a serial command with the label
“dmp.SerialDelay.” The value that you specify for dmp.SerialDelay represents the
delay between sending repeated serial commands from the DMP. By default, the
value is 5000 (milliseconds). If the value is set lower, the delay between messages
is decreased. Note that dmp.SerialDelay does not impact the rate at which other
RS-232 commands are sent when more than one command is lined up for
transmission.
together. For those TVs, you can add and define a serial command with the label
“dmp.SerialDelay.” The value that you specify for dmp.SerialDelay represents the
delay between sending repeated serial commands from the DMP. By default, the
value is 5000 (milliseconds). If the value is set lower, the delay between messages
is decreased. Note that dmp.SerialDelay does not impact the rate at which other
RS-232 commands are sent when more than one command is lined up for
transmission.
To define the delay between repeated serial commands:
1. On the Serial Commands tab for the desired TV type, click the + at the upper
right of the Available Serial Commands list box.
40. Click + at the upper right of the Available Serial Commands box and add a
corresponding command called dmp.SerialDelay.
41. Press Enter.
42. The dmp.SerialDelay will automatically be selected in the available list. Click <<
to add it to the configured list.
43. Select the dmp.SerialDelay command in the configured list and click + at the
upper right of the Serial Strings of Selected Commands. Enter the appropriate
value for the steps (as described above).
value for the steps (as described above).
44. Press Enter.
45. Click Save.