Cisco Cisco StadiumVision Mobile Manual De Mantenimiento
© 2012 Cisco Systems, Inc. All rights reserved.
Page 87 of 103
The new DMP should:
• Belong to the same groups and zones.
• React to the zone/group state actions.
• Display the same content as the DMP its replaces.
• React to the zone/group state actions.
• Display the same content as the DMP its replaces.
Solution:
1. Unplug the failed DMP and replace it with a new DMP.
2. Wait until auto-registration/provisioning completes, and the new DMP shows in
the dashboard with state 'Ready'.
3. In the control panel un-map the old DMP from its Location, and map the new
DMP to this Location.
4. From the control panel manually stage content to the new DMP.
5. Verify that the new DMP is showing the expected content.
6. Delete the failed DMP from Cisco StadiumVision Director. This DMP will be
named as "Unassigned-xx-xx-xx-xx-xx-xx", where xx-xx-xx-xx-xx-xx is the MAC
address.
address.
Configuring CDP in the DMP
The DMP, starting with firmware version SE 2.2.1 build 1932, supports Medianet.
One of the services provided by Medianet is Cisco Discovery Protocol (CDP). This
capability allows the switch and DMP to learn about each other by exchanging CDP
messages. At the switch CLI, the show cdp neighbor command displays the DMPs
that are connected to the switch. This information can be very useful when
troubleshooting DMP issues.
One of the services provided by Medianet is Cisco Discovery Protocol (CDP). This
capability allows the switch and DMP to learn about each other by exchanging CDP
messages. At the switch CLI, the show cdp neighbor command displays the DMPs
that are connected to the switch. This information can be very useful when
troubleshooting DMP issues.
Training_SW#show cdp neighbor
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone,
D - Remote, C - CVTA, M - Two-port Mac Relay
Device ID
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone,
D - Remote, C - CVTA, M - Two-port Mac Relay
Device ID
Local Intrfce Holdtme Capability Platform Port ID
SEP081735D5E79A
Gig 0/1 173 H P M IP Phone Port 1
SEP081735D5E72F
Gig 0/9 174 H P M IP Phone Port 1
00:0f:44:01:b5:50
Gig 0/7 171 H DMP 4310G eth0
SEP081735D5E749
Gig 0/6 174 H P M IP Phone Port 1
sande-cucm
Gig 0/24 137 H VMware Vi eth0
SEP081735D5E6DF
Gig 0/8 175 H P M IP Phone Port 1
00:0f:44:01:a8:d7
Gig 0/10 175 H DMP 4310G eth0
00:0f:44:01:b6:c3
Gig 0/5 167 H DMP 4310G eth0
00:0f:44:01:bf:60
Gig 0/11 177 H DMP 4310G eth0