Cisco Cisco StadiumVision Mobile Reporter Manual De Mantenimiento
© 2011 Cisco Systems, Inc. All rights reserved.
Page 52 of 103
Note: To see the detailed DMP Status, click the Status tab.
Figure 40.
Provisioned DMPs in the Control Panel
Preparing CISCO STADIUMVISION DIRECTOR, DHCP
Server & DMP for Auto Registration
Server & DMP for Auto Registration
Perform the following steps to prepare Cisco StadiumVision Director, the DHCP
Server and the DMP for auto-registration and auto-provisioning.
Server and the DMP for auto-registration and auto-provisioning.
1. Enable auto-registration and auto-provisioning in the Cisco StadiumVision
2. For auto-registration to work DHCP for the DMPs must be set to “on” under
Cisco StadiumVision Director Configuration. By default DHCP is enabled on a
new 2.4 install, but double check to make sure it has not been changed.
new 2.4 install, but double check to make sure it has not been changed.
3. Setup the DHCP Server with options that enable the DMP to discover and
section.
4. Verify that the DMPs being deployed are auto-registration capable. This requires
that they are running SE2.2.1 build 1932 or later, or DMS 5.2.2 or later. At the
time of writing both these versions have been available for at least 6 months and
it can be assumed that all units shipped from factory are imaged with auto-
registration capable firmware. Units that have been sitting on the shelf at a
distributor for an extended period of time may arrive with an older version that
does not support auto-registration.
time of writing both these versions have been available for at least 6 months and
it can be assumed that all units shipped from factory are imaged with auto-
registration capable firmware. Units that have been sitting on the shelf at a
distributor for an extended period of time may arrive with an older version that
does not support auto-registration.