Cisco Cisco StadiumVision Mobile Manual De Mantenimiento
© 2011 Cisco Systems, Inc. All rights reserved.
Page 63 of 94
Viewing Auto Provisioning Status on the TV
During the auto provisioning workflow, the TV screen displays:
The barcode for the DMP MAC address.
A ticker showing the MIB variables, IP address, CDP variables, and switch
settings.
Intermediate status of the auto provisioning. This tells you what step you are on
in the auto provisioning, what step is next, and what is happening to the DMP
(e.g, transitioning to the ready state).
(e.g, transitioning to the ready state).
When auto provisioning is finished, a “Completed!” status message and the default
video channel displays on the TV. If the Completed! message does not display, auto
provisioning was unsuccessful.
video channel displays on the TV. If the Completed! message does not display, auto
provisioning was unsuccessful.
Viewing the DMP Readiness State in the Control Panel
To view which state (Not Ready, Ready, In Production) the DMP is in during auto
registration and provisioning:
registration and provisioning:
1. Open the Control Panel.
2. Select Setup > Devices.
3. Select the Locations & DMP tab to display DMP information, including the
current state. The State column will display „Ready‟ when the DMP is ready to be
mapped to a location. Refer to Figure 52.
mapped to a location. Refer to Figure 52.
Figure 52.
Viewing the DMP Readiness State