Cisco Cisco StadiumVision Mobile Reporter Manual De Mantenimiento
© 2011 Cisco Systems, Inc. All rights reserved.
Page 50 of 94
Figure 45.
Serial Commands Screen
2. From the Available Serial Commands list, select the command or commands
that you wish to add and click <<. This adds the command name to the list of
Configured Serial Commands.
Configured Serial Commands.
If the command you wish to configure is not in the list of Available Serial
Commands, click the + at the upper right of the list box and enter the label you
wish to use for the new command.
Commands, click the + at the upper right of the list box and enter the label you
wish to use for the new command.
3. Highlight the serial command in the Configured Serial Commands list.
4. Click the + above the Serial Strings of Selected Commands list.
5. Enter the appropriate serial string. This string will now be associated with the
highlighted serial command for this device.
Defining Volume Commands
StadiumVision Director allows you to define volume controls that are relative
(volume up and volume down) or explicit (volume number). Relative volume
commands depend on the volume increments set in the TV, which may vary widely
from model to model. Therefore, the preferred method is to use explicit volume
controls.
(volume up and volume down) or explicit (volume number). Relative volume
commands depend on the volume increments set in the TV, which may vary widely
from model to model. Therefore, the preferred method is to use explicit volume
controls.
Explicit Volume Commands
To define explicit volume controls for the attached TV, you must first define the
desired number of increments (levels) between minimum and maximum volume,
then for each increment define a corresponding serial command.
desired number of increments (levels) between minimum and maximum volume,
then for each increment define a corresponding serial command.