Cisco Cisco 1 GHz GainMaker Amplifier Guía De Instalación
Chapter 2 Installation and Configuration
Signal Flow from Right to Left
Note: Coax In may be switched with the Coax Out if you reverse the amplifier
module and feed the signal from right to left.
5
Using a ½-inch torque wrench, tighten the strand clamp bolts from 5 ft-lb to 8 ft-lb
(6.8 Nm to 10.8 Nm). Make sure there is good mechanical contact between the strand
and the housing.
Note: A slight tilt of the face of the housing is normal. Cable tension will cause the
Note: A slight tilt of the face of the housing is normal. Cable tension will cause the
housing to hang more closely to vertical.
6
Connect the coaxial cable to the pin connector according to connector manufacturer
specifications.
7
Proceed to Installing Accessories (on page 28).
To Install the Housing in a Pedestal
Complete the following steps to install the node in a pedestal.
1
Remove the cover of the pedestal.
2
Remove the self-tapping bolts from the strand clamps and set the bolts and strand
clamps aside.
3
Position the housing in the pedestal frame as shown in the following illustration.
Line up the self-tapping bolt holes on the bottom of the housing with the mounting
holes on the bracket.
26
OL-31155-01