Cisco Cisco 1 GHz GainMaker Amplifier Guía De Instalación
Chapter 2 Installation and Configuration
36
Removing the Amplifier Module from the Housing
To Remove the Amplifier Module
Complete the following steps to remove the amplifier module.
1 Open the housing. Refer to To Open the Amplifier Housing (on page 13).
2 If you are working with an amplifier station in which AC is present, remove the
1 Open the housing. Refer to To Open the Amplifier Housing (on page 13).
2 If you are working with an amplifier station in which AC is present, remove the
AC shunt power directors from the amplifier before removing the amplifier
module from the housing.
module from the housing.
CAUTION:
RF connectors and housing seizure assemblies can be damaged if AC shunt
power directors are not removed from the amplifier before installing or
removing the amplifier module from the housing.
RF connectors and housing seizure assemblies can be damaged if AC shunt
power directors are not removed from the amplifier before installing or
removing the amplifier module from the housing.
3 Unplug the 10-pin keyed connector of the power cable harness from the amplifier
module.
4 Remove the power cable harness from the white plastic retainer clips.
5 Unsnap the cable guide from the holes in the amplifier module cover.
5 Unsnap the cable guide from the holes in the amplifier module cover.
Note: The cable can remain plugged into the power supply module.
6 Using a flat-blade screwdriver, loosen the four module retainer screws.