Cisco Cisco 1 GHz GainMaker Amplifier Guía De Instalación
vi
741338 Rev D
Important Safety Instructions,
Continued
Installation Site
When selecting the installation site, comply with the following:
•
•
Protective Ground - The protective ground lead of the building’s electrical installation
should comply with national and local requirements.
•
Environmental Condition – The installation site should be dry, clean, and ventilated. Do
not use this equipment where it could be at risk of contact with water. Ensure that this
equipment is operated in an environment that meets the requirements as stated in this
equipment’s technical specifications, which may be found on this equipment’s data sheet.
Installation Requirements
WARNING:
Allow only qualified service personnel to install this equipment. The installation must
conform to all local codes and regulations.
Equipment Placement
WARNING:
Avoid personal injury and damage to this equipment. An unstable mounting surface
may cause this equipment to fall.
To protect against equipment damage or injury to personnel, comply with the following:
•
•
Install this equipment in a restricted access location.
•
Do not install near any heat sources such as radiators, heat registers, stoves, or other
equipment (including amplifiers) that produce heat.
•
Place this equipment close enough to a mains AC outlet to accommodate the length of this
equipment’s power cord.
•
Route all power cords so that people cannot walk on, place objects on, or lean objects
against them. This may pinch or damage the power cords. Pay particular attention to
power cords at plugs, outlets, and the points where the power cords exit this equipment.
•
Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold
with this equipment.
•
Make sure the mounting surface or rack is stable and can support the size and weight of
this equipment.
•
The mounting surface or rack should be appropriately anchored according to
manufacturer’s specifications. Ensure this equipment is securely fastened to the mounting
surface or rack where necessary to protect against damage due to any disturbance and
subsequent fall.
Ventilation
This equipment has openings for ventilation to protect it from overheating. To ensure
equipment reliability and safe operation, do not block or cover any of the ventilation
openings. Install the equipment in accordance with the manufacturer’s instructions.