Cisco Cisco 862 MHz GainStar Amplifier Guía De Instalación
Chapter 2 Installation and Configuration
Attaching the Coaxial Connectors
To Prepare the Line Extender Module for Connector Installation
Complete the following steps to trim longer pins.
1 Loosen the RF connector bolts.
1 Loosen the RF connector bolts.
2 The GainStar Line Extender requires pin-type connectors for all RF connections.
The 5/8’’ RF connector will be needed for pins extending from 33 mm to 35 mm
(1.3 in. to 1.4 in). The PG11 RF connector will be needed for pins extending 29
mm to 31 mm (1.1 in. to 1.2 in). You must trim longer pins before inserting them
into the housing. If the center conductor pin extends beyond the STRIP line on
the housing, trim the pin flush to the STRIP line. The following diagram shows a
visual guide of the center conductor trim length.
14
OL-31945-02