Cisco Cisco Prisma II EDR Receiver Guía De Instalación
4-8
Operation Using LCI
78-748705-01 Rev C
Connect the Computer to the Chassis
Introduction
Before you start the LCI software, you must first connect your computer to the
chassis that contains the module(s) you want to check.
Important: The LCI software communicates only with those modules located in the
Important: The LCI software communicates only with those modules located in the
chassis your computer is attached to. To check other modules, you must connect
your computer to the chassis where the modules reside.
Connecting to the Chassis
Follow these steps to connect your PC to the chassis.
1.
Plug the female end of a 9-pin serial extension cable into your computer.
2.
Plug the male end of the cable into the Local Craft Interface port.