Cisco Cisco OptoStar II Driver Amplifier Guía De Instalación
Continued on next page
Operating using ICIM LCD
This section describes how to use the OptoStar II ICIM LCD to operate the
OptoStar II forward driver amplifier module.
OptoStar II forward driver amplifier module.
Start
1. Make sure that the RF cables of the OptoStar II forward driver amplifier
module are connected.
2. Turn the front panel switch of the OptoStar II power supply module to ON
position. The power supply module and the forward driver amplifier module
will initialize for about 5 seconds, and the ICIM will load for about 25
seconds.
will initialize for about 5 seconds, and the ICIM will load for about 25
seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
warm-up.
The LCD now displays ICIM loading screen as shown below.
3. When the device initialization is complete, remove the ICIM display and
begin operation.
Continued on next page
3-4
Operation
OL-29667-02