Cisco Cisco OptoStar II Driver Amplifier Guía De Instalación

Descargar
Página de 59
Operating using ICIM LCD 
This section describes how to use the OptoStar II ICIM LCD to operate the 
OptoStar II intelligent communications interface module.   
Start 
1.  Make sure that the fiber and RF cables of other modules in the OptoStar II 
Platform are connected. 
 
2.  Turn the front panel switch of the OptoStar II power supply module to ON 
position. The power supply module and other modules will initialize for 
about 5 seconds, and the ICIM will load for about 25 seconds.
 
Note: The system will achieve optimal working condition after one hour’s 
warm-up.
 
The LCD now displays ICIM loading screen as shown below. 
 
3.  When the device initialization is complete, remove the ICIM display and 
begin operation. 
 
 
Continued on next page 
 
 
OL-29660-03 
Operation 
3-3