Cisco Cisco OptoStar II 1310nm Transmitter Guía De Instalación
Monitoring Interfaces, Continued
The table below lists the basic parameters of the OptoStar II reverse receiver
module.
module.
Basic Parameter
Description
Module Basic Information
Module Node Location
Module Node Location
Shows the node IP where the modules are
located
S/N
Shows module serial number
Module Firmware Version
Shows module firmware version
Slot ID
Shows slot ID
Module Temperature
Shows the current module temperature (°C)
Parameters for Each Module
Optical Input Power
Optical Input Power
Shows optical input power (dBm)
Optical Input Status
Shows optical input status: Normal/Fault
Setup Parameters
The table below lists the setup parameters of the OptoStar II reverse receiver
module.
module.
Setup
Parameters
Description
Factory Default
Parameters for Each Module
Gain Control
Mode
Shows/sets AGC or MGC gain
control mode
AGC mode for all
four modules
Shows/sets gain (In AGC mode the
field is grayed out; In MGC mode
the function is available: gain range
-20 to 0 dB, turn-off at -30 dB, with 1
dB step)
0 dB (In AGC mode)
Comment
Comment
You may add applicable comments
as required.
None
Continued on next page
3-34
Operation
OL-29665-03