Cisco Cisco OptoStar II 1310nm Transmitter Guía De Instalación
Starting up the Module
Initialization
When the OptoStar II reverse receiver module is powered on, the module will
perform a self-test.
Follow these steps to perform the self-test:
1. Turn the front panel switch of the OptoStar II power supply module to ON
perform a self-test.
Follow these steps to perform the self-test:
1. Turn the front panel switch of the OptoStar II power supply module to ON
position.
2. When the reverse receiver module starts up, it will perform a booting
initialization for about 5 seconds.
3. During the initialization, the laser LED and the alarm LED on the front panel
will be illuminated, and the communication status is shut off.
4. Once the initialization is completed, the status indicator will return to normal.
Communication is enabled and the module is operational.
CAUTION:
•
The module must be initialized; any equipment that cannot be initialized must
be returned to the manufacturer for repair.
be returned to the manufacturer for repair.
•
When everything becomes stable, the module still needs to warm up for at least
one hour, to make sure that its performance is normal.
one hour, to make sure that its performance is normal.
Continued on next page
3-2
Operation
OL-29663-03