Cisco Cisco OptoStar II Driver Amplifier Guía De Instalación

Descargar
Página de 71
General Troubleshooting Information, Continued 
 
Alarm 
Possible Cause 
Servicing Instruction 
Low RF Output 
Level 
 
Low optical output 
power in reverse 
transmitter of the 
node 
 
Connectors between 
the reverse 
transmitter and the 
optical splitter 
mismatch 
 
Connectors between 
the reverse 
transmitter and the 
optical splitter 
contain dusts or 
contaminants 
 
Splitter failure 
 
Fiber connector and 
the reverse receiver 
connector mismatch 
 
Cable or connector 
failure at RF output 
port 
 
Amplifier chip 
failure – gain 
degraded 
 
Check the optical output 
power in reverse transmitter 
of the node 
 
Check whether all the optical 
connectors match 
 
Make sure all the mating 
surfaces of the fiber are clean 
 
Check whether the RF 
connectors match, and check 
for connector failure 
 
Check splitter for optical 
signal 
 
Check whether the optical 
input power is between 
-16dBm and +2dBm with an 
optical power meter 
 
Select Automatic Gain 
Control mode to adjust the 
RF output level 
 
Measure whether the RF 
strength at RF output meets 
the specification: optical 
input power is -10 dBm to +2 
dBm, OMI = 16%, AGC 
mode; RF output 31 
dBmV/channel 
 
Select Manual Gain Control 
mode to adjust the RF output 
level 
 
Measure whether the RF 
strength at RF output meets 
the specification: optical 
input power is -7 dBm, OMI 
= 16%, MGC mode, gain 0 
dB; RF output 37 
dBmV/channel 
 
If the RF output level is still 
lower than the specifications, 
contact the manufacturer for 
servicing 
 
Continued on next page 
OL-29663-03 
Troubleshooting 
4-5