Cisco Cisco Unified CallConnector for Microsoft Windows
Cisco Systems, Inc.
Page
66
66
Cisco Unified CallConnector Mobility Service
Technical Overview
Setup Hunt Group for DISA calls:
Setup a hunt group to provide a pilot number for the Dial-In Access calls. perform the following
steps.
steps.
Hunt Group Configuration
Directory numbers to be included in a hunt group must be already configured in Cisco Unified CME.
Summary Steps
Step 1.
enable
Step 2.
configure terminal
Step 3.
ephone-hunt hunt-tag {longest-idle | peer | sequential}
Step 4.
pilot number [secondary number]
Step 5.
list number[, number...]
Step 6.
exit
Step 7.
end
DETAILED STEPS
Command or Action
Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
•
Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
ephone-hunt hunt-tag {longest-
idle | peer | sequential}
idle | peer | sequential}
Example:
Router(config)# ephone-hunt 23
sequential
sequential
Enters ephone-hunt configuration mode to define an
ephone hunt group.
ephone hunt group.
•
hunt-tag—Unique sequence number that
identifies this hunt group during configuration tasks.
Range: 1 to 100.
Range: 1 to 100.
•
sequential—Ephone-dns ring in the left-to-right
order in which they are listed when the hunt group is
defined.
defined.
Step 4
pilot number [secondary
number]
number]
Defines the pilot number, which is the number that
callers dial to reach the hunt group.
callers dial to reach the hunt group.
•
number—E.164 number up to 27 characters.