Cisco Prisma FiberLinX Modules (1310 1550 nm) Hoja De Datos
Page 2 of 5
Features
Switch Selectable Protocol
o Operates at T1 (1.544), E1 (2.048), and J1 (1.544) protocols
Remote management
o Conduct loopback tests, monitor/manage units via GUI-Based PrismaView
o Full bit rate for customer traffic
o Full bit rate for customer traffic
Supports more fiber choices
o Available for multi-mode or single-mode fiber
o Single-strand fiber versions
o Supports very long fiber distances
o Single-strand fiber versions
o Supports very long fiber distances
Eases Troubleshooting
o Three loopback testing modes plus SNMP management and LEDs assist in diagnosing problems on
fiber optic networks
Typical Application
Prisma T1/E1/J1 media converters allow the user to link two PBXs, CSUs, or routers and extend the distance
between the two over fiber.
between the two over fiber.
Figure 2. Two-Fiber Block Diagram
Host Site
Remote Site
T1/E1/J1 Module
Single or Multi Mode Fiber
T1/E1/J1
PBX
T1/E1/J1
PBX
T1/E1/J1 Module
TX
RX
TX
RX
Figure 3. Single-Strand Fiber Block Diagram
Host Site
Remote Site
T1/E1/J1 Module
Single Strand Fiber
T1/E1/J1
PBX
T1/E1/J1
PBX
T1/E1/J1 Module
RX
TX
RX
TX
SNMP Management
Prisma T1/E1/J1 modules are easy to configure and manage with the GUI-based PrismaView SNMP management
application software or with any other SNMP application. PrismaView runs standalone on Windows NT4/2000/XP,
or as a plug-in to HP OpenView on Windows or Solaris. For users of Windows 98 and other operating systems, a
Java version is also available. Features and functionality are configurable via the software and/or hardware DIP
switch settings.
application software or with any other SNMP application. PrismaView runs standalone on Windows NT4/2000/XP,
or as a plug-in to HP OpenView on Windows or Solaris. For users of Windows 98 and other operating systems, a
Java version is also available. Features and functionality are configurable via the software and/or hardware DIP
switch settings.