Cisco Cisco Unified Contact Center Enterprise 8.5(1) Referencia técnica
28
NEC PG Setup
4. Configuration of the PIM is the only NEC-specific portion of the PG
Setup. Select the Peripheral Name and Peripheral ID. Configure the
IP address of the OAI/Infolink interface of the NEC switch. You
can find this by using the AIPT command of the NEC IMXMAT
utility. See the chapter on NEC Switch Configuration, for more
information. The Port Number Start and Port Number End should be
set to the port number of the first port in the 16 port range of ports
provided by the NEC switch – this is currently 1024, but NEC may
change this in the future. Click OK.
IP address of the OAI/Infolink interface of the NEC switch. You
can find this by using the AIPT command of the NEC IMXMAT
utility. See the chapter on NEC Switch Configuration, for more
information. The Port Number Start and Port Number End should be
set to the port number of the first port in the 16 port range of ports
provided by the NEC switch – this is currently 1024, but NEC may
change this in the future. Click OK.
Figure 8: NEAX2400 Configuration Screen
5. Enter the DMP Properties as indicated in the Installation Guide for
Cisco Unified ICM. Click Next.
Figure 9: DMP Properties Screen