Cisco Cisco Prisma II EDR Receiver Guía De Instalación
Chapter 2 Module Installation
18
78-4023013-01 Rev C
Prisma II XD Chassis
1 Attach a 75-ohm RF cable to the appropriate RF source.
2 Locate the RF ports at the back of the chassis.
1 Attach a 75-ohm RF cable to the appropriate RF source.
2 Locate the RF ports at the back of the chassis.
3 Attach the other end of the RF cable to Port A connector (RF IN) of the
corresponding slot where the module is to be installed. This is the RF input
connection.
4 If F-connectors are installed, use a 7/16-in. open-end wrench to secure both
cables to the connectors at the chassis.