Cisco Cisco SF302-08PP 8-port 10 100 PoE+ Managed Switch Referencia técnica
25
78-21485-01 Command Line Interface Reference Guide
413
Power over Ethernet (PoE) Commands
25.1
power inline
Use the power inline Interface Configuration mode command to configure the
inline power administrative mode on an interface.
inline power administrative mode on an interface.
Syntax
power inline
auto [time-range time-range-name]
power inline
never
Parameters
•
auto—Turns on the device discovery protocol and applies power to the
device.
device.
•
never—Turns off the device discovery protocol and stops supplying power
to the device.
to the device.
•
time-range-name—Specifies a time range. When the time range is not in
effect the power is not supplied the attached device. If a time range is not
specified, there is no time range bounded to the port. (Range: 1–32
characters)
effect the power is not supplied the attached device. If a time range is not
specified, there is no time range bounded to the port. (Range: 1–32
characters)
Default Configuration
The default configuration is set to auto.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The never parameter cannot be used with a time range.
Example
The following example turns on the device discovery protocol on port 4.
switchxxxxxx(config)# interface gi
4