Cisco Cisco FirePOWER Appliance 8390 Notas de publicación
Version 5.3.0.2
Sourcefire 3D System Release Notes
15
Updating Your Appliances
11. Reapply device configurations to all managed devices.
TIP!
To reactivate a grayed-out Apply button, edit any interface in the device
configuration, then click Save without making changes.
12. Reapply access control policies to all managed devices.
Applying an access control policy may cause a short pause in traffic flow and
processing, and may also cause a few packets to pass uninspected. For more
information, see the Sourcefire 3D System User Guide.
Using the Shell to Perform the Update
Although Sourcefire recommends that you use the web interface on your
Defense Centers to perform updates, there may be rare situations where you
need to update the appliance using the bash shell.
IMPORTANT!
Do not use the shell to update a fresh, unconfigured (Version 5.3)
installation of the Sourcefire 3D System. Before you update an appliance using
the shell, make sure that you complete its initial setup using its web interface.
IMPORTANT!
Do not use the shell to update Sourcefire Software for X-Series.
Instead, use the managing Defense Center as described in
For the Version 5.3.0.2 update, all appliances reboot. Managed devices do not
perform traffic inspection, switching, routing, NAT, VPN, or related functions
during the update. Depending on how your devices are configured and deployed,
the update process may also affect traffic flow and link state. For more
information, see
To install the update using the shell:
1. Read these release notes and complete any required pre-update tasks.
For more information, see
2. Download the appropriate update from the
•
for Series 2 Defense Centers:
Sourcefire_3D_Defense_Center_Patch-5.3.0.2-55.sh
•
for Series 3 and virtual Defense Centers:
Sourcefire_3D_Defense_Center_S3_Patch-5.3.0.2-55.sh
•
for Series 2 managed devices:
Sourcefire_3D_Device_Patch-5.3.0.2-55.sh