Cisco Cisco FirePOWER Appliance 7030 Notas de publicación
Version 5.3.0.6
Sourcefire 3D System Release Notes
43
Features Introduced in Previous Versions
AMP8150, which is shipped with additional storage). Malware storage packs are
also supported on stacked or clustered 8000 Series devices (except for the
AMP8150).
Compatible managed devices detect if a malware storage pack is added and
Compatible managed devices detect if a malware storage pack is added and
automatically transfer existing file captures to the added drive, freeing space on
the main drive.
WARNING!
Do not attempt to install third-party hard drives. Installing an
unsupported hard drive may damage the device.
Sourcefire Software for X-Series
S
UPPORTED
D
EVICES
: X-Series
Version 5.3 of the Sourcefire 3D System is now supported on X-Series appliances
running X-Series Operating System (XOS) Version 9.7.2 (and later) and Version
10.0 (and later). If you are using an earlier version of XOS, contact Blue Coat
Systems Support. For more information about X-Series, see the Sourcefire
Software for X-Series Installation and Configuration Guide.
Virtual Appliance Initial Setup Improvements
L
ICENSE
: Any
S
UPPORTED
D
EVICES
: Virtual, X-Series
S
UPPORTED
D
EFENSE
C
ENTERS
: Virtual
As of Version 5.3, you can perform the initial setup on virtual devices without
leaving the vCloud workflow by using the vSphere Hypervisor or the vCloud
Director. You no longer need to connect to the virtual device console to change
the default password, configure networking, set the initial detection mode, and
configure the managing Defense Center during initial setup. Those configuration
steps can now all be performed during the vCloud deployment workflow. Note
that you can still deploy using ESXi, but that it requires additional setup on the
VMware console.
Changed Functionality
•
You can now use a shell-based query management tool to locate and stop
long-running queries. The query management tool allows you to locate
queries running longer than a specified number of minutes and stop those
queries. The tool logs an event to the audit log and to syslog when you stop
a query.
Note that only administrative users with shell access rights on the Defense
Note that only administrative users with shell access rights on the Defense
Center can access this tool. For more information, type
query_manager -h
on the Defense Center shell or see Stopping Long-Running Queries in the
Sourcefire 3D System User Guide.