Cisco Cisco UCS C460 M1 High-Performance Rack-Mount Server Hoja De Datos
Cisco UCS 6200 Series Fabric Interconnect
SUPPLEMENTAL MATERIAL
33
Transceivers and Cabling
The 6200 fabric interconnect series supports SFP+ Ethernet transceivers, SFP transceivers, and SFP Fibre
Channel transceivers.
Channel transceivers.
SFP+ Transceivers
The high bandwidth of 10-Gigabit Ethernet poses challenges to transmissions that are met by the
transceiver and cabling options supported by the Cisco UCS 6200 platform.
transceiver and cabling options supported by the Cisco UCS 6200 platform.
The enhanced SFP+ 10-Gigabit Ethernet transceiver module is a bidirectional device with a transmitter and
receiver in the same physical package. It has a 20-pin connector on the electrical interface and duplex LC
connector on the optical interface.
receiver in the same physical package. It has a 20-pin connector on the electrical interface and duplex LC
connector on the optical interface.
lists the supported SFP+ transceiver options.
SFP Transceivers
The SFP 1-Gigabit Ethernet transceiver module is a bidirectional device with a transmitter and receiver in
the same physical package.
the same physical package.
lists the supported SFP transceiver options.
SFP+ Copper Cables
Copper cables are available for use with the 10-Gigabit Ethernet SFP+ module.
lists the
supported cable options.
On the Cisco UCS 6200 platforms, you can use an innovative Twinax copper cable that connects to standard
SFP+ connectors for in-rack use. For longer runs, you can use an optical cable.
SFP+ connectors for in-rack use. For longer runs, you can use an optical cable.
For in-rack or adjacent-rack cabling, the Cisco UCS 6200 platform supports SFP+ direct-attach 10-Gigabit
Ethernet copper, which integrates transceivers with Twinax cables into an energy efficient, low-cost, and
low-latency solution. SFP+ direct-attach 10-Gigabit Twinax copper cables use only 0.1 watts of power per
transceiver and introduce only approximately 0.25 microsecond of latency per link.
Ethernet copper, which integrates transceivers with Twinax cables into an energy efficient, low-cost, and
low-latency solution. SFP+ direct-attach 10-Gigabit Twinax copper cables use only 0.1 watts of power per
transceiver and introduce only approximately 0.25 microsecond of latency per link.
For longer cable runs, the Cisco UCS 6200 platform supports multimode, short-reach optical SFP+
transceivers. These optical transceivers use approximately 1 W per transceiver and have a latency of less
than 0.1 microsecond.
transceivers. These optical transceivers use approximately 1 W per transceiver and have a latency of less
than 0.1 microsecond.
SFP Fibre Channel Transceivers
The Cisco UCS 6200 series fabric interconnects support multimode 850nm 4 Gbps and 8 Gbps SFPs with 150m
reach (see
reach (see
).