Cisco Cisco Content Security Management Appliance M1070 Guía De Instalación
9
9
Log In to the Appliance
You can log into the Cisco M690 using one of two interfaces:
the web-based interface or the command line interface.
the web-based interface or the command line interface.
Web-Based Interface
Step 1
For web browser access via the Ethernet port (see the
), go to the
Cisco M690 appliance management interface by
entering the following URL in a web browser:
entering the following URL in a web browser:
http://192.168.42.42
Step 2
Enter the following login information:
•
Username: admin
•
Password: ironport
Note
The hostname parameter is assigned during system
setup. Before you can connect to the management
interface using a hostname (http://hostname), you must
add the appliance hostname and IP address to your
DNS server database.
setup. Before you can connect to the management
interface using a hostname (http://hostname), you must
add the appliance hostname and IP address to your
DNS server database.
Step 3
Click Login.
Command-Line Interface
Step 1
Access the command-line interface locally or remotely:
•
To access the CLI locally, set up a terminal to
connect to the serial port using 9600 bits, 8 bits, no
parity, 1 stop bit (9600, 8, N, 1) and flow control
set to Hardware. To physically connect the
terminal, see the
connect to the serial port using 9600 bits, 8 bits, no
parity, 1 stop bit (9600, 8, N, 1) and flow control
set to Hardware. To physically connect the
terminal, see the
M690_QSG.fm Page 9 Thursday, March 31, 2016 5:43 PM