Cisco Cisco Web Security Appliance S170 Guía Del Usuario
2-10
AsyncOS 10.0 for Cisco Web Security Appliances User Guide
Chapter 2 Connect, Install, and Configure
System Setup Wizard
Before You Begin:
•
Connect the Appliance to networks and devices. See
.
•
Complete the System Setup Wizard worksheet. See
•
If you are setting up a virtual appliance:
–
Use the
loadlicense
command to load the virtual appliance license. For complete information,
see the Cisco Content Security Virtual Appliance Installation Guide, available from
–
Enable the HTTP and/or HTTPS interfaces: In the command-line interface (CLI), run the
interfaceconfig
command.
•
Note that reference information for each configuration item used in the System Setup Wizard is
available at
available at
.
Warning
Only use the System Setup Wizard the first time you install the appliance or if you want to completely
overwrite the existing configuration.
overwrite the existing configuration.
Step 1
Open a browser and enter the IP address of the Web Security appliance. The first time you run the System
Setup Wizard, use the default IP address:
Setup Wizard, use the default IP address:
https://192.168.42.42:8443
-or-
http://192.168.42.42:8080
where
192.168.42.42
is the default IP address, and
8080
is the default admin port setting for HTTP,
and
8443
is default admin port for HTTPS.
Otherwise, if the appliance is currently configured, use the IP address of the M1 port.
Step 2
When the appliance login screen appears, enter the user name and passphrase to access the appliance.
By default, the appliance ships with the following user name and passphrase:
By default, the appliance ships with the following user name and passphrase:
•
User name:
admin
•
Passphrase:
ironport
Step 3
You must immediately change the passphrase.
Step 4
Choose System Administration > System Setup Wizard.
If the appliance is already configured, you will be warned that you are about to reset the configuration.
To continue with the System Setup Wizard, click the Reset Configuration button. The appliance will
reset and the browser will refresh to the appliance home screen.
To continue with the System Setup Wizard, click the Reset Configuration button. The appliance will
reset and the browser will refresh to the appliance home screen.
Step 5
Read and accept the terms of the end-user license agreement.
Step 6
Click Begin Setup to continue.
Step 7
Configure all settings using the reference tables provided in the following sections as required. See
.
Step 8
Review the configuration information. If you need to change an option, click Edit for that section.