Cisco Cisco Web Security Appliance S170 Guía Del Usuario
22-16
AsyncOS 10.0 for Cisco Web Security Appliances User Guide
Chapter 22 Perform System Administration Tasks
Managing Alerts
Step 3
Configure the alert settings as required.
Step 4
Submit and commit your changes.
Alert Listing
The following sections list alerts by classification. The table in each section includes the alert name
(internally used descriptor), actual text of the alert, description, severity (critical, information, or
warning) and the parameters (if any) included in the text of the message.
(internally used descriptor), actual text of the alert, description, severity (critical, information, or
warning) and the parameters (if any) included in the text of the message.
Option
Description
From Address to Use
When Sending Alerts
When Sending Alerts
The RFC 2822 compliant “Header From:” address to use when sending
alerts. An option is provided to automatically generate an address based on
the system hostname (“alert@<hostname>”)
alerts. An option is provided to automatically generate an address based on
the system hostname (“alert@<hostname>”)
Wait Before Sending a
Duplicate Alert
Duplicate Alert
Specifies the time interval for duplicate alerts. There are two settings:
Initial Number of Seconds to Wait Before Sending a Duplicate Alert. If
you set this value to 0, duplicate alert summaries are not sent and instead, all
duplicate alerts are sent without any delay (this can lead to a large amount of
email over a short amount of time). The number of seconds to wait between
sending duplicate alerts (alert interval) is increased after each alert is sent.
The increase is the number of seconds to wait plus twice the last interval. So
a 5 second wait would have alerts sent at 5 seconds, 15, seconds, 35 seconds,
75 seconds, 155 seconds, 315 seconds, etc.
you set this value to 0, duplicate alert summaries are not sent and instead, all
duplicate alerts are sent without any delay (this can lead to a large amount of
email over a short amount of time). The number of seconds to wait between
sending duplicate alerts (alert interval) is increased after each alert is sent.
The increase is the number of seconds to wait plus twice the last interval. So
a 5 second wait would have alerts sent at 5 seconds, 15, seconds, 35 seconds,
75 seconds, 155 seconds, 315 seconds, etc.
Maximum Number of Seconds to Wait Before Sending a Duplicate Alert.
You can set a cap on the number of seconds to wait between intervals via the
maximum number of seconds to wait before sending a duplicate alert field.
For example, if you set the initial value to 5 seconds, and the maximum value
to 60 seconds, alerts would be sent at 5 seconds, 15 seconds, 35 seconds, 60
seconds, 120 seconds, etc
You can set a cap on the number of seconds to wait between intervals via the
maximum number of seconds to wait before sending a duplicate alert field.
For example, if you set the initial value to 5 seconds, and the maximum value
to 60 seconds, alerts would be sent at 5 seconds, 15 seconds, 35 seconds, 60
seconds, 120 seconds, etc
Cisco AutoSupport
Specifies whether or not to send Cisco the following support information:
•
a copy of all alert messages generated by the system
•
weekly reports noting the uptime of the system, the output of the
status
command, and the AsyncOS version used.
Also specifies whether or not to send internal alert recipients a copy of every
message sent to Cisco. This applies only to recipients that are set to receive
System alerts at Information severity level.
message sent to Cisco. This applies only to recipients that are set to receive
System alerts at Information severity level.