Cisco Cisco Content Security Management Appliance M390 Guía Del Usuario
13-5
Cisco IronPort AsyncOS 8.0 for Security Management User Guide
Chapter 13 Common Administrative Tasks
The resume Command
mail3.example.com> resume
Receiving resumed.
Mail delivery resumed.
mail3.example.com>
Resetting to Factory Defaults
When physically transferring the appliance, you may want to start with factory defaults. The Reset
button in the Reset Configuration section of the Management Appliance > System Administration >
Configuration File page, or the resetconfig command, resets all AsyncOS configuration values to
factory defaults. This command is extremely destructive, and it should only be used when you are
transferring the unit or as a last resort to solving configuration issues. It is recommended that you run
the System Setup Wizard after resetting the configuration.
button in the Reset Configuration section of the Management Appliance > System Administration >
Configuration File page, or the resetconfig command, resets all AsyncOS configuration values to
factory defaults. This command is extremely destructive, and it should only be used when you are
transferring the unit or as a last resort to solving configuration issues. It is recommended that you run
the System Setup Wizard after resetting the configuration.
Note
The
resetconfig
command works only when the appliance is in the offline state. When the resetconfig
command completes, the appliance is automatically returned to the online state. If mail delivery was
suspended before you issued the resetconfig command, the mail will attempt to be delivered again when
the resetconfig command completes.
suspended before you issued the resetconfig command, the mail will attempt to be delivered again when
the resetconfig command completes.
Warning
The
resetconfig
command will return all network settings to factory defaults, potentially
disconnecting you from the CLI, disabling services that you used to connect to the appliance (FTP,
Telnet, SSH, HTTP, HTTPS), and even removing additional user accounts you created with the
Telnet, SSH, HTTP, HTTPS), and even removing additional user accounts you created with the
userconfig
command. Do not use this command if you are not able to reconnect to the CLI using the
Serial interface or the default settings on the Management port through the default admin user
account.
account.
The resetconfig Command
mail3.example.com> offline
Delay (seconds, minimum 30):
[30]> 45
Waiting for listeners to exit...
Receiving suspended.
Waiting for outgoing deliveries to finish...
Mail delivery suspended.
mail3.example.com> resetconfig
Are you sure you want to reset all configuration values? [N]> Y
All settings have been restored to the factory default.