Cisco Cisco Content Security Management Appliance M160 Guía Del Usuario
13-36
Cisco IronPort AsyncOS 8.0 for Security Management User Guide
Chapter 13 Common Administrative Tasks
Changing Network Settings
This section describes the features used to configure the network operation of the Cisco IronPort
appliance. These features give you direct access to the hostname, DNS, and routing settings that you
configured using the System Setup Wizard in
appliance. These features give you direct access to the hostname, DNS, and routing settings that you
configured using the System Setup Wizard in
The following features are described:
•
sethostname
•
DNS configuration (in the GUI and by using the
dnsconfig
command in the CLI)
•
Routing configuration (in the GUI and by using the
routeconfig
and
setgateway
commands in the
CLI
)
•
dnsflush
•
Password
Changing the System Hostname
The hostname is used to identify the system at the CLI prompt. You must enter a fully qualified
hostname. The s
hostname. The s
ethostname
command sets the name of the Cisco IronPort appliance. The new hostname
does not take effect until you issue the
commit
command.
The sethostname Command
oldname.example.com> sethostname
[oldname.example.com]> mail3.example.com
oldname.example.com>
For the hostname change to take effect, you must enter the
commit
command. After you have successfully
committed the hostname change, the new name appears in the CLI prompt:
oldname.example.com> commit
Please enter some comments describing your changes:
[]> Changed System Hostname
Changes committed: Mon Jan 04 12:00:01 2010
The new hostname appears in the prompt as follows:
mail3.example.com>
SYSTEM.SERVICE_
TUNNEL.DISABLED
Sent when a tunnel created for Cisco IronPort Support
Services is disabled.
Services is disabled.
Information
SYSTEM.SERVICE_
TUNNEL.ENABLED
Sent when a tunnel created for Cisco IronPort Support
Services is enabled.
Services is enabled.
Information
Table 13-4
Listing of System Alerts (continued)
Alert Name
Description
Severity