Cisco Cisco Prisma II EDR Receiver Guía De Instalación
78-748704-01 Rev C
Installation
2-11
Connect Optical Cables,
Continued
Connecting an Optical Cable to the Processor
Before proceeding, place a protective cap over the end of the cable to protect it while
it is being pulled. Using a protective cap is generally a good idea when handling a
cable at any time.
WARNING:
Avoid damage to your eyes! Do not look into any optical connector while the
system is active. Even if the unit is off, there may still be hazardous optical
levels present.
Follow these steps to pull the cable to the front of the chassis.
1.
While facing the front of the chassis, insert the fiber fish tool through the slot
located just above the bottom of the chassis.
2.
At the rear of the chassis, locate the appropriate optical cable.
3.
Insert the optical cable into one of the notches on the fiber fish tool.
4.
Pull the fiber fish tool (with cable attached) to the front of the chassis.
5.
Disengage the cable from the fiber fish tool and remove the protective cap
from the cable.
6.
Attach the cable to the appropriate connector on the processor front panel.