Cisco Cisco Email Security Appliance C370D Guía De Instalación
10
The appliance may not appear to have accepted your
configuration or be performing the installation. This is
because you have changed the IP address, but the
installation is underway.
configuration or be performing the installation. This is
because you have changed the IP address, but the
installation is underway.
Step 7
If you temporarily changed the IP address of your
computer as described in the
computer as described in the
change the IP address settings back to the original
values.
values.
Step 8
Ensure that your laptop and the appliance are
connected to the network.
connected to the network.
Step 9
Log back in to the appliance with the username admin
and the new password that you set in the System Setup
Wizard.
and the new password that you set in the System Setup
Wizard.
The Cisco C190 Email Security Appliance uses a
self-signed certificate that may trigger a warning from
your web browser. You can simply accept the certificate
and ignore this warning.
self-signed certificate that may trigger a warning from
your web browser. You can simply accept the certificate
and ignore this warning.
Step 10
Write down your new administrator password and
keep it in a safe place.
keep it in a safe place.
12
Run the Active Directory Wizard
(Optional)
After running the System Setup Wizard in the web interface, the
Active Directory Wizard appears. If you are running an Active
Directory server on your network, use the Active Directory
Wizard to configure an LDAP server profile for the Active
Directory server.
Active Directory Wizard appears. If you are running an Active
Directory server on your network, use the Active Directory
Wizard to configure an LDAP server profile for the Active
Directory server.
If you are not using Active Directory or want to configure it
later, click Skip this Step. You can run the Active Directory
Wizard later by going to System Administration > LDAP. Select
the “using Active Directory Wizard” check box, and then click
Add LDAP Server Profile.
later, click Skip this Step. You can run the Active Directory
Wizard later by going to System Administration > LDAP. Select
the “using Active Directory Wizard” check box, and then click
Add LDAP Server Profile.