Cisco Cisco FirePOWER Appliance 7030
55-14
FireSIGHT System User Guide
Chapter 55 Using Health Monitoring
Configuring Health Policies
To configure Discovery Event Status module settings:
Access:
Admin/Maint
Step 1
In the Health Policy Configuration page, select
Discovery Event Status
.
The Health Policy Configuration — Discovery Event Status page appears.
Step 2
Select
On
for the
Enabled
option to enable use of the module for health status testing.
Step 3
In the
Critical Seconds since last event
field, enter the maximum number of seconds to wait between events,
before triggering a critical health status.
Step 4
In the
Warning Seconds since last event
field, enter the maximum number of seconds to wait between
events, before triggering a warning health status.
Step 5
You have three options:
•
To save your changes to this module and return to the Health Policy page, click
Save Policy and Exit
.
•
To return to the Health Policy page without saving any of your settings for this module, click
Cancel
.
•
To temporarily save your changes to this module and switch to another module’s settings to modify,
select the other module from the list at the left of the page. If you click
select the other module from the list at the left of the page. If you click
Save Policy and Exit
when you
are done, all changes you made will be saved; if you click
Cancel
, you discard all changes.
You must apply the health policy to the Defense Center for your settings to take effect. See
for more information.
Configuring Disk Status Monitoring
License:
Any
Use the Disk Status health module to monitor the current status of your appliance’s hard disk, and
malware storage pack if installed. This module generates a Warning (yellow) health alert when the hard
disk and RAID controller (if installed) are in danger of failing, or if an additional hard drive is installed
that is not a malware storage pack. This module generates an Alert (red) health alert when an installed
malware storage pack cannot be detected.
malware storage pack if installed. This module generates a Warning (yellow) health alert when the hard
disk and RAID controller (if installed) are in danger of failing, or if an additional hard drive is installed
that is not a malware storage pack. This module generates an Alert (red) health alert when an installed
malware storage pack cannot be detected.
To configure Disk Status health module settings:
Access:
Admin/Maint
Step 1
On the Health Policy Configuration page, click
Disk Status
.
The Health Policy Configuration — Disk Status page appears.
Step 2
Select
On
for the
Enabled
option to enable use of the module for health status testing.
Step 3
You have three options:
•
To save your changes to this module and return to the Health Policy page, click
Save Policy and Exit
.
•
To return to the Health Policy page without saving any of your settings for this module, click
Cancel
.
•
To temporarily save your changes to this module and switch to another module’s settings to modify,
select the other module from the list at the left of the page. If you click
select the other module from the list at the left of the page. If you click
Save Policy and Exit
when you
are done, all changes you made will be saved; if you click
Cancel
, you discard all changes.